Standard ASTM D2835-89R03
1.1 This specification covers a lubricant suitable for facilitating the insertion and positioning of preformed elastomeric compression seals in prepared voids (usually contraction joint
s) in concrete pavement. For changes to this Standard since the last issue, refer to the Summary of Changes Section at the end of the Standard.
1.2 The requirements of the lubricant are based on the performance of the lubricant as measured by its solids content, homogeneity, consistency and drying rate.
1.3 The values stated in inch-pound units are to be regarded as the standard. The metric equivalents of U.S customary units may be approximate.
1.4 The following precautionary caveat pertains only to the test method portion, Section 7 of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.