ASTM D7606-17

Standard Practice for Sampling of High Pressure Hydrogen and Related Fuel Cell Feed Gases

ACTIVE

About this standard

Languages
English
Type
ASTM
Status
ACTIVE
Publication date
01 November 2017
Withdrawn Date

About this training

Summary

< div class=" SectionLevel2" > < p class=" subsec1 cdone2" > < span class=" Head3 cdone" > 1.1< / span> & #x00a0 This standard practice describes a sampling procedure of high pressure hydrogen at fueling stations operating at 35 or 70 megapascals (MPa) using a hydrogen quality sampling apparatus (HQSA).

< / div> < div class=" SectionLevel2" > < p class=" subsec1 cdone2" > < span class=" Head3 cdone" > 1.2< / span> & #x00a0 This practice does not include the analysis of the acquired sample. Applicable ASTM standards include but are not limited to test methods referenced in Section < span class=" Body-link1 cdone" > 2< / span> of this practice.

< / div> < div class=" SectionLevel2" > < p class=" subsec1 cdone2" > < span class=" Head3 cdone" > 1.3< / span> & #x00a0 This practice is not intended for sampling and measuring particulate matter in high pressure hydrogen. For procedures on sampling and measuring particulate matter see ASTM < span class=" Body-link1 cdone" > D7650< / span> and < span class=" Body-link1 cdone" > D7651< / span> .

< / div> < div class=" SectionLevel2" > < p class=" subsec1 cdone2" > < span class=" Head3 cdone" > 1.4< / span> & #x00a0 The values stated in SI units are standard. The values stated in inch-pounds are for information only.

< / div> < div class=" SectionLevel2" > < p class=" caveat cdone2" > < span class=" Head3 cdone" > 1.5< / span> & #x00a0 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

< / div> < div class=" SectionLevel2" > < p class=" WTOcaveat cdone2" > < span class=" Head3 cdone" > 1.6< / span> & #x00a0 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

< / div>