< div class=" SectionLevel2" > < p class=" subsec1 cdone2" > < span class=" Head3 cdone" > 1.1< / span>  This specification provides the minimum requirements for pressure-retaining components of fluid conditioner fittings. It addresses the pressure-retaining component design, fabrication, rating, marking, and testing.

< / div> < div class=" SectionLevel2" > < p class=" subsec1 cdone2" > < span class=" Head3 cdone" > 1.2< / span>  This specification is not intended to override any of the present fluid conditioner fitting specifications specific to devices such as strainers, filters, and traps but should be used for devices for which a specific specification does not apply.

< / div> < div class=" SectionLevel2" > < p class=" subsec1 cdone2" > < span class=" Head3 cdone" > 1.3< / span>  This specification provides sufficient requirements to allow a fluid conditioner fitting to be used in the marine environment.

< / div> < div class=" SectionLevel2" > < p class=" subsec1 cdone2" > < span class=" Head3 cdone" > 1.4< / span>  The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

< / div> < div class=" SectionLevel2" > < p class=" caveat cdone2" > < span class=" Head3 cdone" > 1.5< / span>  < span style=" font-style:normal font-weight:normal " class=" overriddenformat" > The following precautionary caveat pertains only to the test methods portion, Section < span class=" Body-link1 cdone" > 7< / span> , of this specification. < / span> This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

< / div> < div class=" SectionLevel2" > < p class=" WTOcaveat cdone2" > < span class=" Head3 cdone" > 1.6< / span>  This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

< / div>