Standard ASTM F2764_F2764M-18

Standard Specification for 6 to 60 in. [150 to 1500 mm] Polypropylene (PP) Corrugated Double and Triple Wall Pipe and Fittings for Non-Pressure Sanitary Sewer Applications
Status
:
Replaced
Publication date
:
2018
Languages
:
EN
ICS
:
91.140.80 Drainage systems
Summary :

1.1 This specification covers requirements and test methods for corrugated double and triple wall polypropylene pipe and fittings. The nominal inside diameters covered are 6 to 60 in. [150 to 1500 mm].

1.2 The requirements of this specification are intended to provide pipe and fittings for underground use for non-pressure sanitary sewer systems. Pipe and fittings produced in accordance with this specification shall be installed in compliance with Practice D2321.

1.3 This specification covers pipe and fittings with an annular corrugated wall and an essentially smooth interior wall (that is, double wal
l) (Fig. 1) and pipe and fittings with an annular corrugated wall and an essentially smooth interior and exterior wall (that is, triple wal
l) (Fig. 2).

FIG. 1 Typical Corrugated Double Wall Pipe

Typical Corrugated Double Wall PipeTypical Corrugated Double Wall Pipe

FIG. 2 Typical Corrugated Triple Wall Pipe

Typical Corrugated Triple Wall PipeTypical Corrugated Triple Wall Pipe

1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.5 The following precautionary statement applies only to Section 7 of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Add to cart
EUR 60.00 (excl. VAT)
Select your language
Viewer title
...
The NBN uses cookies to improve your user experience. By continuing to use this site you agree to our use of cookies as described in the NBN privacy statement.
Decline