Norme NBN ISO/IEC 29341-30-2:2021
Technologies de l'information — Architecture de dispositif UPnP — Partie 30-2: Protocole de contrôle de dispositif de gestion et de contrôle de l'Internet des objets — Dispositif de gestion et de contrôle de l'Internet des objets (ISO/IEC 29341-30-2:2017)
Statut
:
Active
Date de publication
:
5/2021
Langues
:
EN
ICS
:
35.200 Matériel d'interface et d'interconnexion
Sommaire :
This document defines the device for IOT Management and Control, which identifies Level 1
of the device named IOT Management and Control. This Publicly Available Specification is
applicable to Standardized DCPs of the UPnP Forum which include this device.
This device definition is compliant with the UPnP Device Architecture version 1.0 [1]. It
defines a device type referred to herein as IOT Management and Control device.
This specification defines a general-purpose device that can be used to instantiate a bridge or
gateway device that is connected to Sensors and Actuators. This device implements a bridge
between the UPnP network and Sensors/Actuators endpoints. It exposes services to check
the status, and send and receive data from Sensors. Sensors/Actuators may be connected
using a variety of transport protocols including Bluetooth, ZigBee and IEEE 11073.
The device defined herein provides the following capabilities:
1. Access and control of multiple Sensors and Actuators.
2. Expose configuration information from Sensors and Actuators.
Figure 1 — IOT Management and Control Device Functional Diagram
The shaded boxes represent UPnP services that are contained by the IOT Management and
Control device. The un-shaded boxes represent device specific modules that are vendor
specific.